Product is brand new.
Features:
| • | MinuteMan Plus saves you hours when you?re testing batteries, starters, alternators, regulators, and charging systems.Features:? Special AGM test options for accurately diagnosing AGM and spiral (six-pack style) batteries? Can switch between English and Spanish languages with a menu-based selectionBattery TestingThe way it has been: Your customer brings in a dead battery and you have to charge it up to test it. Then, if it?s a keeper, you have to recharge it. Hardly efficient use of your valuable time. With MinuteMan Plus on the job, you can test discharged batteries down to as low as two volts, and it won?t drain a charged battery you are testing.You won?twaste time charging bad batteries. Works on all 12-volt automotive-type batteries with cold cranking amp ratings of 100-1500. This includes batteries found in motor-vehicle, marine, agricultural, forestry, and industrial applications. The tester operates from either110 volts AC or its own internal, rechargable 6-volt battery. Featres self-calibration, an internal battery check, and an automatic shut-down to reduce power consumption.On certain competitive, carbon-pile load battery testers, the technician must interpret the readings, then make the electrical system diagnosis. With MinuteMan Plus, all you have to do is read simple test results on the LCD display.Starter TestingThe MinuteMan Plus display shows cranking volts and amps, and indicates either "Good Starter" or "Bad Starter." Excessive starter current draw can indicate a defective starter. Excessive engine drag, due to tight or damaged bearings or piston drag, can also cause an abnormally high starter draw.Charging System TestingChecks the charging system at high rpms and at idle, and stores the data. Results show regulator volts, peak amps, and a diode condition. MinuteMan Plus utilizes waveform analysis when testing alternator diodes, which provides more accuracy than the commonly used "ripple voltage" tests.Battery Tachometer CapabilityUnique, patented direct-from-battery technology gives you tachometer readings without having to make complicated connections to the ignition system. Provides battery-sensing measurements to 4,000 rpm, with 1 rpm resolution. |
|
|
Standard UPS and Fedex transit times:
| Ground |
2-7 business
days depends on location |
| Third day
air |
3 business
days |
| Second day
air |
2 business
days |
| *Next day
air (please call) |
1 business
day |
*Upon customer request only.
*Please note 2nd and 3rd day air cutoff times for shipping is 12pm est.
Truck Deliveries
Most of our trucking carriers offer Curb Side Delivery
to customers location. Curbed Side Delivery means it is the responsibility of
the customer who is receiving the shipment to have the means to unload by (fork
lift or loading dock)
Please note larger items that have free shipping on ground delivery (Cement
Mixers, Panel saws, log splitters) Toolfetch pays the shipping to a commercial/business
address assuming the location has a fork lift, loading dock or man power to
remove the product off the truck. Toolfetch does not pay for Residential fees
or lift gate service, this is responsibility of the customer. One of our shipping
personal will contact you prior to processing your order with (Residential fees,
or liftgate fee if required).
Toolfetch offers different options for truck deliveries:
Commercial/Business Address:
If Toolfetch ships to a commercial address (assuming
customer has a forklift or loading dock) Toolfetch will pay the shipping.
If liftgate service is required additional fees will be added depending on
the freight carrier. A Toolfetch shipping representative will contact you
and ask you if you need this additional service. Toolfetch is not responsible
if the product cannot be unloaded off the truck. Truck drivers are not deemed
responsible to help unload the product off the truck. Please note if you operate
your business out of residential address you will be charged for the additional
costs of delivering to a residential address
Residential address:
(Larger Items such as Cement Mixers, Panel Saws, Generators
etc..)
Trucking carriers impose additional shipping costs to a residential address.
The additional fee is due to shipping carriers not being able to use 18
wheelers down residential streets and need to switch to smaller trucks.
Toolfetch is not responsible for additional shipping costs to a residential
address.
Additional costs for residential delivery can range from $30-65 depending
on shipping carriers.. Larger items that are heavy over 70 lb. customers
should request lift gate service. Liftgate service charges can range from
$40 - 100 depending on carrier. A Toolfetch representative will call prior
to processing the order and discuss these additional costs
If the customer does not request lift gate service Toolfetch is not responsible
if the product cannot be removed from the truck. Please note truck drivers
are not deemed responsible to help unload the product off the truck .If
the driver or customer cannot unload the product it will be brought back
to the shipping depot. The customer is responsible for making a 2nd delivery
attempt and will be charged accordingly
Pickup from Terminal:
An alternative to shipping to a residential or commercial/business
address is shipping the unit to a shipping terminal. If the customer requests
to ship to a terminal we can make arrangements with our shipping carriers
for the customer to pickup the unit from the terminal. Toolfetch will determine
the closest terminal to the customers location prior to processing the order.
Please note you must bring proper identification to the terminal.
Products that have the icon free shipping
on ground deliveries:
Items under 70 lb. (lasers,
carts, powertools, buckets, etc...) that have free shipping on ground
delivery will be shipped regular UPS ground or FedEx Ground.
Items over 70 Ib. (Cement Mixers, Log Splitters,
Generators, kettles, rail saws etc...) that have free shipping on
ground delivery will be shipped by freight truck. Please note these items
can only ship ground service. Toolfetch has free shipping to commercial/business
addresses assuming the location has a loading dock or fork lift present
to remove the item off the truck. Toolfetch does not pay for additional
residential fees or lift gate service (please see residential
address section for additional costs). These additional costs are the
responsibility of the customer. A Toolfetch representative will call prior
to processing the order and ask if the customer is shipping the product
to a residential address or commercial address and if you require lift gate
service.
UPS and FedEx:
Most items under 70 pounds ship by UPS or FedEx
Please note UPS and FedEx cannot ship to a PO Box.
If shipping to Hawaii or Alaska the shipment will be mailed Second day air
only
Back Orders:
If an item is purchased from Toolfetch that is backordered
you will be notified via email immediately. We will keep you updated on the
backorder status of the product or we will offer substitute products if the
product cannot ship in a timely fashion.
International Shipping:
If you are shipping outside of the United States please see our international shipping
page for shipping quotes and payment information. Please click here for our international shipping page
Canadian Shipping:
If you are shipping to Canada please see our Canadian international shipping
page for shipping quotes and payment information. Please click here for our Canadian international shipping page
|
The Lease Procedure
At NuCorp Financial Services, we make leasing as easy as 1-2-3! Most applicants
can be approved up to $75,000.00 with a simple one-page application.
Step 1
Client expresses interest in leasing the equipment from the equipment vendor.
Client completes the NuCorp Financial Services Equipment Application and returns
it to NuCorp via fax or email.
Step 2
Lease Consultant processes the application and calls the client to go over the
terms of the approval. Upon a verbal agreement on terms, a lease proposal is
sent to client. Once lease proposal is returned, the lease documents are prepared
and sent out to client.
Step 3
Client sends back the lease documents and NuCorp reviews the documents and completes
verbal verification. Once verbal is completed, the lease is funded and commenced.
A check is sent out overnight to the equipment vendor.
Download the Nucorp Equipment Lease Application here
What Are The Benefits of Leasing?
Leasing Conserves Capital. Leasing eases the strain on working capital
by providing 100% financing. This means that your client has more money available
to invest in profit generating activities. It converts a large cash sale price
into a low, affordable, tax-deductible monthly payment. Rather than tying up
their bank line of credit or using cash operating funds, leasing allows an additional
source of capital for equipment. Taxes, delivery, service contracts and other
soft costs not typically financed by a bank can also be included in the cost
of the lease.
Tax Benefits. Lease rental payments are made from pre-tax rather than
after-tax earnings. Lease payments may be fully deductible, consult an accountant.
The cost of leasing is an operating expense, and is therefore tax deductible
for the life of the lease. This is usually shorter than the normally allowable
depreciation schedule. In most cases, tax benefits of a lease transaction are
more beneficial to a company than an outright purchase.
Fixed Rate Lease Payments. No variable interest rates here. Fixed payments
enable a lessee to more accurately predict equipment costs and cash needs.
Avoid Obsolescence. Buying promotes keeping equipment far beyond its
useful life. Out-dated equipment is often shuttled downstream or stored away
until it is less than worthless (sold for less than the costs of selling). Equipment
leasing protects your clients company from having to keep obsolete equipment.
Trade-in, add-on and upgrade capabilities allow your clients to make the needed
adjustments as your business grows.
About NuCorp
Established in 1998, NuCorp, Inc. has been assisting entrepenuers and business owners with financing options for over a decade. As lease consultants, we advise our clients on the ideal options for their business. The world of business is complicated and unpredictable. NuCorp Financial Services is dedicated to leveraging that playing field. We have strong relationships with some of the world's largest financial institutions. We have also built partnerships with specialized vendors to bring our clients quality, reliable equipment.
NuCorp Financial Services specializes in leasing commercial equipment from $1000.00 to $250,000.00. We understand the benefits of reserving capital and provide answers and a resource for all types of businesses. By offering every available funding resource, flexible payment programs, and including our own warehouse line to our clients, we can provide the leasing resource our clients need
NuCorp Financial Services specializes in leasing commercial equipment from $1000.00 to $250,000.00. We understand the benefits of reserving capital and provide answers and a resource for all types of businesses. By offering every available funding resource, flexible payment programs, and including our own warehouse line to our clients, we can provide the leasing resource our clients need
Contact Information
Please call our professional leasing/Financing agent Jesse Zuckerman for any questions
949-273-6383 Ext. 119
|
|
|
